Convert your stock Super Beetle drum brakes to disc brakes with AC Industries No-Hassle disc brake kit. No need to change spindles. This bolt on kit will fit any stock Super Beetle drum spindle. Rotors come drilled with two sets of pilot holes for Porsche Pattern (One Set Threaded for Lug Nuts and One Set for Press in Studs). Studs and installation must be purchased extra. This kit will NOT add to the off set of the car. Bearings and Seals not included.
THIS KIT CANNOT BE USED WITH WITH BACKING PLATES!
Kit Includes: (2) Rotors, (2) Caliper Mounting Brackets, (2) Calipers w/Pads and (1) Caliper Mounting Hardware. Kit re-uses backing plate bolts to mount Caliper Bracket.
When installing this kit you will need two extra 10" metal lines (not included)
Stud Installation Note: These drums/rotors are drilled for the correct stud size but must still be reamed to the finish size to obtain the proper press fit. Skipping this step will result in improperly installed studs or damage to the drum/rotor.
If you wish to have press-in studs installed please order the following:
Press-In Wheel Stud Installation Part# SI4L, Sold ea. (One Install Charge Required per Drum/Rotor)
Porsche Press-in Wheel Studs (50mm Long) Part# 601850, Sold ea. (5pcs Required per Drum/Rotor)
Porsche Press-in Wheel Studs (56mm Long) Part# 70-2810-0, Sold ea. (5pcs Required per Drum/Rotor)
Bearing & Seal Kit - (1 ea Part# 498490L)
10" Metal Lines - (2 ea Part# 113611735D)
For more information, please visit this products
webpage.
Call Us: (562)633-4979 
Email Us: 
